LandX X10

Specification:

Length, m 10

Width, m 2.5

Transom Deadrise, deg 16.8

Engine type outboard

Max recommended HP 2 x 250

Transom height, m 0.625

Weight (no engine), kg 3100

Fuel Capacity, l 400

Max recommended load, kg 2300

Capacity 5

Marine aluminium alloy 5083

CE category C

STANDARD EQUIPMENT

EXTERIOR EQUIPMENT

- Hull made of 5083 grade marine aluminium; material thickness 5 mm bottom and 4 mm side walls

- Bow loading ramp with electric lift and additional locks for rigid securing to the hull

- Spacious self-draining slip-resistant deck made of checkered aluminium (3 drain holes on each side)

- Hull wrapped in grey vinyl film with additional edge treatment to prevent water ingress

- Heavy-duty welded bollards (6 pcs) located along the hull

- Decorative EVA finish inside the cabin

- Non-slip EVA coating on the stern platforms (port and starboard sides of the engine)

- 4 lifting eyes for crane launch and recovery, reinforced for the average weight of the placed cargo

- Shelves for storage along the sides

- Service access ports on the fuel tank

- Technical hatch for quick access to the bilge

- Cabin glazing made of tinted and tempered glass

- Bow opening door for loading and unloading cargo

INTERIOR EQUIPMENT

- Passenger cabin spanning the full width of the vessel (port to starboard)

- Hydraulic steering system for single or twin engine configuration

- Steering wheel

- Pilot and passenger seats — swivel; captain's seat with slider

- Front and rear cabin doors with fixators in the open position for ventilation

- Rear seat cushions in the cabin (removable)

- One large rear locker/bench seat (full width of the cabin) with two access hatches

- Cabin ceiling lighting — 4 pcs, two modes: white/red

- Upholstered ceiling panel with quick-release clips for easy access

- Backup manual bilge pump located at the stern

ELECTRICAL EQUIPMENT

- 2 x Main switch (divided by groups: engines/navigation and winch/bow ramp)

- 3 x Automatic bilge pump with manual override (installed in aft and bow sections)

- Control panel with 6 switches

- Fuse panel divided by consumer/circuit type

- Bow thruster (electric, includes full installation and joystick on captain's console)

- Electric lift for the bow ramp

- Navigation lights (LED, port and starboard; anchor light on rear of cabin)

- Top light (LED)

- 2 x batteries included

AVAILABLE OPTIONS

1. Comfort & Heating

- Diesel heater incl. fuel tank

- A/C system incl. inverter and water intake installation

- Shock absorbing pedestal for captain and passenger seat

- Extended cabin (+50 cm)

- Opening side windows (port and starboard)

2. Deck & Hull

- Trim tabs with manual controller

- Pushknees with rubber bumper

- Engine guard (single or twin)

- Rubberized gunwale along port and starboard sides

3. Interior

- Cabinet incl. sink, drawers, pump, freshwater tank and grey water tank

- Toilet

4. Electrical

- Solar panel + controller

- White/red chart table LED lamp

- Deck lighting (front and rear)

- LED spotlights for outdoor use on the roof

- Shore power system

- Shore power + inverter, 3 x 220V sockets, charger and isolator

- Extended battery group (4 batteries total)

5. Navigation

- VHF radio

- GPS / chartplotter with installation

- GPS / chartplotter + radar with installation

- Navigation map (MicroSD)

- Radar base

6. Crane

- Crane base and counterweight

- Marine-grade crane with hydraulic winch and stainless steel fittings

7. Engines

- Single outboard engine (petrol or diesel)

- Twin outboard engines (petrol or diesel)

8. Customisation

- Vinyl wrap in custom colour (standard: grey)

- Company logo

- Hull painting in required colour